I have a trek fuel Ex9 14 if I change the press fit Shimano bb to the GXP bb these should fit can some one confirm?Sorry. GXP, so 24mm stepped.
yes they will fit in a GXP press fit BB.I have a trek fuel Ex9 14 if I change the press fit Shimano bb to the GXP bb these should fit can some one confirm?
I have a bottom bracket dealer ... Mmmmm $207.50Thanks Mitch.
$215 registered post and you can have them Minlak - the BB is going to cost you more than the crankset :behindsofa:
If you get a hope bb, they have an adapter ring for GXP, so you could run either standard. They do frivolous ceramic tooI will let them pass for now until I look into a bb a bit more thanks
My main concern is the Trek size I have an inkling I need to get a special GXP bottom bracket to fit. However press fit should be press fit I found stuff when I was trying to get a 30mm oneIf you get a hope bb, they have an adapter ring for GXP, so you could run either standard. They do frivolous ceramic too
I have a buyer at $212 for them gotta make something......:whistle: you're like the Anti-chops......
Just hanging out for the WTF? I have X bike, Y BB and Z cranks. How to make them fit post.....its been far to serious today.I have a buyer at $212 for them gotta make something......
The actual Chronological order will be:-Just hanging out for the WTF? I have X bike, Y BB and Z cranks. How to make them fit post.....its been far to serious today.
Better jump on the SLX now, there's a set you'd never find cheaper anywhere else up at the moment.The actual Chronological order will be:-
1) XT cranks with 1 x ring for sale (Sold)
2) How do i remove the press fit bearings
3) Can they repair the housing of the pressfit bearing on the frame will magic metal work
4) Does this look right? Why dont they fit
5) Sram cranks with 1 x for sale
6) Hit up ebay for some SLX cranks